Siemens SINUMERIK 840D sl Function Manual page 738

N4: Punching and nibbling - only 840D sl
10.4 Automatic path segmentation
If the programmed path segmentation is not an integral multiple of the total path, then the
feed path is reduced:
X2/Y2:
SPP:
SPP':
Figure 10-4
Example of SPN
The number of path segments per block is programmed via SPN.
A value programmed via SPN takes effect on a non-modal basis for both punching and
nibbling applications. The only difference between the two modes is with respect to the first
stroke. This is normally executed at the beginning of the first segment with nibbling
operations and at its end with punching operations. This means that when n segments are
programmed, n strokes are executed with punching operations but n+1 with nibbling.
Furthermore, where no travel information is available, only a single stroke is executed, even
if several are programmed. Should it be necessary to generate several strokes at one
position, then the corresponding number of blocks without traversing information must be
programmed.
N1 G01 X0 Y0 SPOF
N2 X75 SPN=3 SON
:
:
:
:
738
Programmed traversing distance
Programmed SPP value
Automatically rounded-off offset distance
Path segmentation
; position without punch initiation
; Activate nibbling. The total path is divided into
; 3 segments. A stroke is initiated before the first
; movement and at the end of each segment.
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
Extended Functions