Operation
6.4 Command sources
6.4.4
"PROFIdrive+TM31" default setting
Preconditions
● The Power Module, Control Unit, TM31 and PROFIBUS have been correctly installed.
● The "PROFIdrive+TM31" default setting was chosen during commissioning:
• STARTER (p0700):
• AOP30 (p0700):
Command sources
Figure 6-15
Priority
The command source priorities are shown in the diagram "Command sources - AOP30 <->
PROFIdrive+TM31".
Note
LOCAL master control
All of the supplementary setpoints are deactivated for LOCAL master control.
210
"PROFIdrive+TM31"
"4: PROFIdrive+TM31"
Command sources - AOP30 <-> PROFIdrive+TM31
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A