Igmp Snooping Multicast Vlan Commands - D-Link DES-1228 Reference Manual

The IGMP Snooping Multicast VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
create igmp_snooping
multicast_vlan
config igmp_snooping
multicast_vlan
config igmp_snooping
multicast_vlan_group
show igmp_snooping
multicast_vlan_group
delete igmp_snooping
multicat_vlan
enable igmp_snooping
multicast_vlan
disable igmp_snooping
multicast_vlan
show igmp_snooping
multicast_vlan
Each command is listed, in detail, in the following sections.
create igmp_snooping multicast_vlan
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
IGMP S
NOOPING
Parameters
<vlan_name 32> <vlanid 2-4094>
<vlan_name 32> {[add| delete] [member_port <portlist> | tag_member_port <portlist>
|source_port <portlist>]|state [enable | disable]|replace_source_ip [<ipaddr>|none]}(1)
<vlan_name 32> [ add <mcast_address_list> | delete [<mcast_address_list>
| all]]
{< vlan_name 32> }
<vlan_name 32>
{<vlan_name 32>}
Used to create a multicast VLAN
create igmp_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094>
The create igmp_snooping multicast_vlan command will create a multicast_vlan. Multiple
multicast VLAN can be configured.
The ISM VLAN being created can not exist in the 1Q VLAN database. Multiple ISM VLAN
can be created. The ISM VLAN snooping function co-exist with the 1Q VLAN snooping
function.
<vlan_name> − The name of the VLAN to be created. Each multicast VLAN is given a
name that can be up to 32 characters.
<vlanid> – The VLAN ID of the multicast VLAN to be create. The range is 2-4094
Only Administrator-level users can issue this command.
M
ULTICAST
246
37
VLAN C
OMMANDS