D-Link DES-1228 Reference Manual page 107

Command
config mgmt_pkt_priority
show mgmt_pkt_priority
Each command is listed, in detail, in the following sections.
config bandwidth_control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure bandwidth control:
DES-1228/ME:4#config bandwidth_control 1 rx_rate 64
Command: config bandwidth_control 1 rx_rate 64
Note: To perform precise bandwidth control, it is required to enable the flow control
to mitigate the retransmission of TCP traffic.
Success.
DES-1228/ME:4#
show bandwidth_control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
[default | <priority 0-7>]
Used to configure bandwidth control on a port by-port basis.
config bandwidth_control <portlist> {rx_rate [ no_limit | <value 64-1024000>] |
tx_rate [ no_limit | <value 64-1024000>]}(1)
The config bandwidth_control command is used to configure bandwidth on a port by-
port basis.
<portlist> − Specifies a port or range of ports to be configured.
rx_rate − Specifies that one of the parameters below (no_limit or <value 64-1024000>) will
be applied to the rate at which the above specified ports will be allowed to receive packets
no_limit − Specifies that there will be no limit on the rate of packets received by

the above specified ports.
<value 64-1024000> − Specifies the traffic limit, in Kbits, that the above ports will

be allowed to receive.
tx_rate − Specifies that one of the parameters below (no_limit or <value 64-1024000>) will
be applied to the rate at which the above specified ports will be allowed to transmit
packets.
no_limit − Specifies that there will be no limit on the rate of packets received by

the above specified ports.
<value 64-1024000> − Specifies the traffic limit, in Kbits, that the above ports will

be allowed to receive.
Only Administrator-level users can issue this command.
Used to display the bandwidth control table.
show bandwidth_control {<portlist>}
The show bandwidth_control command displays the current bandwidth control
configuration on the Switch, on a port-by-port basis.
<portlist> − Specifies a port or range of ports to be viewed.
None.
102