D-Link DES-1228 Reference Manual page 164

DES-1228/ME:4# config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DES-1228/ME:4#
config 802.1x reauth
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1X reauthentication for ports 1-18:
DES-1228/ME:4#config 802.1x reauth port_based ports 1-18
Command: config 802.1x reauth port_based ports 1-18
Success.
DES-1228/ME:4#
config radius add
Purpose
Syntax
Description
Parameters
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to configure the 802.1X re-authentication feature of the Switch.
config 802.1x reauth {port_based ports [<auth_portlist> | all] | mac_based | ports
[<portlist> | all] {mac_address <macaddr>}]
The config 802.1x reauth command is used to re-authenticate a previously authenticated
device based on port number.
port_based – This instructs the Switch to re-authorize 802.1X functions based only on the
port number. Ports approved for re-authorization can then be specified.
mac_based − This instructs the Switch to re-authorize 802.1X functions based only on the
port number or the MAC address. MAC addresses approved for re-authorization can then
be specified.
ports <auth_portlist> − Specifies a port or range of ports to be re-authorized.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> − Enter the MAC address to be re-authorized.
Only Administrator-level users can issue this command.
Used to configure the settings the Switch will use to communicate with a RADIUS server.
config radius add <server_index 1-3> <server_ip> key <passwd 32> [ default | {
auth_port<udp_port_number 1-65535> | acct_port <udp_port_number 1-65535>}(1)]
The config radius add command is used to configure the settings the Switch will use to
communicate with a RADIUS server.
<server_index 1-3> − Assigns a number to the current set of RADIUS server settings. Up
to 3 groups of RADIUS server settings can be entered on the Switch.
<server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used between the Switch and
the RADIUS server.
<passwd 32> − The shared-secret key used by the RADIUS server and the Switch. Up to
32 characters can be used.
default − Uses the default UDP port number in both the "auth_port" and "acct_port"
settings.
159