Walk Testing - Bosch ICP-EZM2 System Reference Manual

86 en | Device Specifications and Overview
Battery replacement
Battery life
Device testing
Wall and cover tamper switch
Frequency
Table 8.8: Specifications
8.10.1

Walk testing

Perform a walk test to determine the boundaries of the coverage area.
Insert a slotted screwdriver into the designated hole to open the cover and then close the
detector cover to start a 90-sec Walk Test mode.
During this test mode, motion detected within the detector's coverage area causes a
transmitted alarm and LED activation. Each alarm will also extend the Test Mode. Adjust as
necessary.
Notice!
Excessive use of the Walk Test Mode may reduce battery life. Use only for initial setup and
maintenance testing.
Notice!
In the normal operating mode, an alarm can be transmitted only after three (3) minutes have
passed since the previous alarm restoral. This 3 minute lockout time reduces unnecessary RF
transmissions in high traffic areas, thereby extending battery life.
Refer to the LED table below for LED descriptions.
LED condition
Steady blue
Flashing blue
Flashing blue (four-pulse sequence)
2014.09 | 01 | F.01U.306.221
Duracell DL123A, Panasonic CR123A, or Sanyo CR123A.
Check your battery yearly to ensure proper functionality.
Up to 5 years
To ensure proper functionality, the device must be tested
at least once every year by an installer.
Transmits a tamper signal when someone removes the
device from its base or pulls it away from the wall.
433.42 MHz
Cause
PIR activation (Walk Test)
Warm-up period after power-up
PIR failure. Replace unit.
System Reference Guide
Easy Series Control Panel
Bosch Security Systems, Inc.