Installation Considerations; Wiring Considerations; Specifications - Bosch ICP-EZM2 System Reference Manual

76 en | Device Specifications and Overview
8.6.1

Installation considerations

Use the provided anchors and screws to mount the repeater in locations accessible for future
maintenance. Mount the repeater onto a wall.
Notice!
Mount the repeater in a location removed from metal. Metal objects (duct work, wire mesh
screens, boxes) reduce RF range
8.6.2

Wiring considerations

Notice!
Do not install long cable runs next to high-current power feeds. Keep cable lengths as short
as possible to minimize noise pickup.
Ensure that the wiring used meets the following specifications:
–
–
8.6.3

Specifications

Dimensions
Power/Voltage
(Standby battery)
Transformer power/voltage
Current Draw
Wire Gauge
Temperature (operating)
Relative Humidity
Device testing
Wall and Cover Tamper Switch Transmits a tamper signal when someone removes the device from its
Frequency
Table 8.4: Specifications
2014.09 | 01 | F.01U.306.221
Two-conductor unshielded wire.
The minimal requirement for wire length is 1.83 m (6 ft) from the repeater
139.70 mm x 209.60 mm x 31.80 mm
(5.50 in x 8.25 in x 1.25 in)
16.5 VAC, 40VA (~)
(EN voltage range: 16.5 VAC– 18 VAC) AC Type (device)
Rated 3.7 VDC, 3050mAH EVE ENERGY CO Part No P0046-LF (Not user
replaceable). For standby battery to be operative, the tamper switch is
required to be engaged.
Power source type: A
Low battery level: 3.5V
Must meet country specific requirements
60 mA
0.65 mm (22 AWG) to 2.0 mm (18 AWG)
Functional range: -10ﾟC to +49ﾟ(+14ﾟF to +120ﾟF)
EN 50130-5 Class II only: -10ﾟC to 40ﾟC (+14ﾟF to +104ﾟF)
0% to 93% (non-condensing)
To ensure proper functionality, the device must be tested at least once
every year by an installer.
base or pulls it away from the wall.
433.42 MHz
System Reference Guide
Easy Series Control Panel
Bosch Security Systems, Inc.