System Test And Maintenance; Test The System; Maintain The System; Installer History Event Announcements - Bosch ICP-EZM2 System Reference Manual

66 en | System Test and Maintenance
7

System Test and Maintenance

7.1

Test the System

Test the system for proper operation when installation and configuration are complete.
4
4
7.2

Maintain the System

Notice!
After system installation and any control panel programming, perform a complete system test.
A complete system test includes testing the control panel, all devices, and communication
destinations for proper operation.
7.3

Installer History Event Announcements

The Installer Menu speaks the event report status for each event. Refer to Configure the
System, page 32.
After the event entry and its parameters (if any) are spoken, the system will beep and then
speak the status using two numbers. The first number indicates the route 1 event status. The
second number indicates the route 2 event status.
The numbers in each announcement indicate the status as follows:
–
–
–
–
Refer to the following table for a history event announcement example.
Entry Event
Announcement "AC Fail"
7.4

Event Messages

The following table shows:
–
–
Event History Log Entry
Tamper Tamper 0
Enclosure
Duress Duress; System Off User 22
Quick Arm System On Occupied User System
On Unoccupied User 0
System On Custom User 0
2014.09 | 01 | F.01U.306.221
Press the System Test button on the control panel board for one sec. The system
provides instructions throughout the test. Follow all instructions.
Contact the central monitoring station (CMS) to verify that all necessary test reports
were received, including test reports from all installed input and output devices.
0 = The event was logged only
1 = The event was successfully transmitted for this route
2 = The transmission of this event failed for this route
3 = The event is still pending for this route
Tone
Beep
Non-standard event messages that appear in the history log, and
Event messages for SMS Text and Voice formats
System Reference Guide
Route 1 Status
"One"
SMS Text Format
Point Trouble 0
Intrusion Alarm System
Off
System On User 0
Easy Series Control Panel
Route 2 Status
"Zero"
Voice Format
Tamper 0
Duress System Off User 22
System On Occupied User 0
System On Unoccupied User 0
System On Custom User 0
Bosch Security Systems, Inc.