Add Users, Tokens, And Key Fobs; Configure Wireless Devices From Installer Phone Menu - Bosch ICP-EZM2 System Reference Manual

34 en | System Installation and Configuration
As part of the walk test, the control panel checks the signal strength of each wireless point.
System message
"Point xx was tested"
"Point xx, test failed, was tested"
"Point xx"
Fix any issues with the devices and re-test until the system announces "Point xx was tested"
for each point. When the system completes the testing, the system announces "System test
complete."
3.5.5

Add Users, Tokens, and Key Fobs

1.
2.
3.
Change keyfob
1.
2.
3.
4.
5.
6.
3.6

Configure Wireless Devices from Installer Phone Menu

1.
2.
If the point number is not currently assigned to a Wireless ID:
To set Point Type, press [1].
To add a device, press [2].
Press [#] to exit.
If the point number is currently assigned to a Wireless ID:
To set Point Type press [1].
To replace a device, press [3]
To delete this device, press [4].
Press [#] to exit.
2014.09 | 01 | F.01U.306.221
From the User Phone Menu, press [4] to enter the User Menu. Refer to Initiate a Phone
Session from the Control Panel, page 33.
Press [1] to add a new user or press [2] to change information for an existing user.
The next set of options allows you to add tokens, passcodes, or keyfobs to a user, or
record a description.
Press a keyfob button.
If the keyfob is not already registered with the system, the control center announces the
last four digits of the RFID for the device that it found.
If this is the correct RFID for the keyfob you want to add, press [1] to continue. The
control center announces "Keyfob added. Please wait." During this time, the database
and receiver configurations are updated.
If this is not the correct RFID, press [2] to ignore that RFID and have the control panel
look for another keyfob.
Press [#] to return to the User Menu.
Repeat the process to add more users.
Select Wireless Configuration [6] from the System Maintenance menu.
After the system prompt, enter the point number (1 to 32) that you want to configure.
The control panel announces the point number and the point type.
System Reference Guide
Result
The signal strength is good. The point test was
successful.
The signal strength is unacceptable.
The point number is assigned, but not tested.
Easy Series Control Panel
Bosch Security Systems, Inc.