Sony HDV HVR-1500 Service Manual page 160

7. Reattaching the rail assembly
(1) Reattach a new rail assembly to the LED
holder assembly.
(2) Ensure that the two phase determining holes
in the mode gear assembly and in No.3 gear,
which are already aligned in step 7- (2), are
respectively aligned with the two holes in the
MD chassis underneath each gear.
(3) Adjust the two phases determining holes in
No.6 and No.7 gears to align respectively
with the two holes in the MD chassis under-
neath each gear by turning No.7 gear by a
finger.
(4) Turn the gear on the back side of the rail
assembly until the shuttle (R) and shuttle (L)
assemblies push the LED holder assembly as
far as it will go, and align the positioning
hole of the shuttle (L) assembly with the
positioning hole of the rail assembly.
6-44
No.7 gear
No.6 gear
Phase determining Phase determining
hole
hole
No.6 gear
Phase determining hole
Shuttle (L) assembly
Positioning hole
Shuttle (L) assembly
Positioning hole
Phase determining hole
No.7 gear
Shuttle (R) assembly
Rail assembly
Gear
Rail plate
HVR-1500