Mitsubishi Electric GOT1000 Series Handbook page 74

Function
Gateway Monitors controllers of various manufacturers on one GOT or personal
function computer, and sends alarms occurred on the GOT by e-mail.
The function supports remote monitoring and remote maintenance of a
production site from an office.
56
3.3 Overview of Each Function
Overview
Server
RS-422 RS-232
communi- communi-
cation cation
Company A
MITSUBISHI
programmable
programmable
controller
controller
The communication method
is standardized to Ethernet.
Client
[Available connection type for gateway function]
Connection type between GOT and programmable controller
Bus connection
Direct CPU connection
Computer link connection
MELSECNET/H connection (programmable controller to
MITSUBISHI programmable
programmable controller network)
*5
MELSECNET/10 connection (programmable controller to
controller connection
programmable controller network)
CC-Link IE controller network connection
CC-Link connection (intelligent device station)
CC-Link connection (via G4)
Ethernet connection
Serial connection
Third party programmable
Ethernet connection
controller connection
MODBUS /TCP connection
Microcomputer connection
*4
Temperature controller connection
*6
Robot controller connection
Direct CPU connection
MELSECNET/10 connection (programmable controller to
programmable controller network)
*7
CNC connection
CC-Link connection (intelligent device station)
Ethernet connection
*1: When using the MELSECNET/10 connection, use the MELSECNET/H communication
unit. The MELSECNET/10 communication unit is not available.
*2: When using the CC-Link connection, use the CC-Link communication unit
(GT15-J61BT13). The CC-Link communication unit (GT15-75J61BR13-Z) is not available.
*3: The GT16 is applicable to the CC-Link (ID) Ver.2 only.
*4: When connecting a GOT to controllers below, the server/client function is not available.
JTEKT programmable controller
*5: Including connection to the motion controller CPU (Q series and A series), CNC C70, and CRnQ-700
*6: Available only for the CRnD-700.
For the CRnQ-700, refer to the above Mitsubishi programmable controller connection.
*7: Available only for the MELDAS C6/C64.
For the CNC C70, refer to the above Mitsubishi programmable controller connection.
Server Server
RS-422
communi-
cation
Microcomputer
board
Ethernet
Required software is
MX Component only.
MX Component
*1
*2*3
*4
R
*1
*2
SHINKO indicating controller
Reference
Chapter 15 in
GT Designer2
Version2
Screen Design
Manual (For
GOT1000
Series) [SH-
080530ENG]
Chapter 52 in
GOT1000
Series
Connection
Manual [SH-
080532ENG]
GOT1000
Series Gateway
Functions
Manual [SH-
080545ENG]