Toshiba Strata DK 280 Installation Manual page 691

Table 13-l 5
Type 3 Programs - Program 00: Software Check/Remote Maintenance Security Code Assignments
_
,
Step
Action
Display/Printout
1 Enter Program Mode
>MODE PROG
At the
>MODE
prompt, type
PROG,
press
Enter.
P
2
Enter Program Number 00
P 00
Press
Enter.
PO0
3 To Check Software-Version
PO0 0
Version=nmnnnnnnr
Enter Action Code 0. System will display the system's software
PO0
version.
.Common Control type
Press
Enter.
Software version
AI
Special Feature Code
Note:
See note below for Common Control Unit
and Special Feature Code definitions.
4 To Change Level 1 Security Code
PO0 1 0000
Enter Action Code 1. The system will display the present
PO0
level 1 (four-digit) code. Refer to the System Record Sheet
and change if required. Press
Enter.
5
To Change Level 2 Security Code
PO0 2 0000
Enter Action Code 2 The system will display the present
PO0
level 2 (four-digit) code. Refer to the System Record Sheet
and change if required. Press
Enter.
6 To Exit This Program
PO0 ##
Type # # and press
Enter.
P
DK04
General Notes:
Common Con fro/ Types:
H RAAX = RCUTA
W RBAX = RCTUB
n RCAX = RCTUC/D
W RAA3X = RCTUA3
n RBA3X = RCTUBA3/RCTUBB3
H RCA3X = RCTUC3/RCTUD3
Special Feature Codes:
n KEY1 = System with Auto Attendant
H KEY2 = System with ACD and Auto Attendant
H KEY3 = System with MIS and ACD and Auto Attendant
n KEY4 = System Open Architecture (Release 3)
13-28
January 1996