Toshiba Strata DK 280 Installation Manual page 161

Table 4-22
RDDU Controls, Indicators, and Interface Connectors
Control/indicator/Connector
Type of Component
Description
Enables -3dB signal level drop for line Circuit 1
Enables -3dB signal level drop for line Circuit 1
Enables -3dB signal level drop for line Circuit 1
Enables -3dB signal level drop for line Circuit 1
Interface Connector for DID Line circuits 1 & 2
Interface Connector for DID Line circuits 3 & 4
Lights to indicate line circuit 1 is in operation.
(Trunk indicator will not light unless RDDU is
connecteed to a DID line.)
Lights to indicate line circuit 2 is in operation.
(Trunk indicator will not light unless RDDU is
connecteed to a DID line.)
Lights to indicate line circuit 3 is in operation.
(Trunk indicator will not light unless RDDU is
connecteed to a DID line.)
Lights to indicate line circuit 4 is in operation.
(Trunk indicator will not light unless RDDU is
connecteed to a DID line.)
Adjusts for dial pulsing at different loop lengths.
Adjusts for dial pulsing at different loop lengths.
Adjusts for dial pulsing at different loop lengths.
Adjusts for dial pulsing at different loop lengths.
DK0296
3-position slide switch
Pad Switch SW101
Pad Switch SW201 3-position slide switch
Pad Switch SW301 3-position slide switch
Pad Switch SW401 3-position slide switch
Modular Connector Jl Connector
J2 Connector Modular Connector
DID Line Circuit 1 Indicator (1)
(CD122)
Red LED (Top)
DID Line Circuit 2 Indicator (2)
(CD222)
Red LED
DID Line Circuit 3 Indicator (3)
(CD322)
Red LED
Red LED (Bottom)
DID Line Circuit 4 indicator (4)
(CD422)
3-terminal jumper plug
3-terminal jumper plug
Jumper Plug Pi01
Jumper Plug P201
3-terminal jumper plug
Jumper Plug P301
Jumper Plug P401 3-terminal jumper plug
Program 17
Program
QO-Assigns station access to lines
n Assigns Immediate or Wink start to DID lines. Also
(incoming and outgoing).
used to assign Auto camp-on and no-dial tone
Program
41-Assigns station access to lines
return for DID lines. (outgoing only).
n Assigns DID lines to route per DNIS and ANI Program 42-0, I-8-Assigns behind PBX/Centrex
options (Program 71 and 72) or DID numbers
operation to each line.
(Program *09).
Programs 45
- 48-Defines Toll Restriction for any
Program 30-Disables RRCS for dial pulse operation.
line.
Program
39-Assigns line access buttons to digital
Programs 50 -
56-Defines Least Cost Routing
and electronic telephones. assignments.
I
January
1996 4-45