Toshiba Strata DK 280 Installation Manual page 437

Program 05 -
Flexible Access Code Numbering
~i~rm~~~~~~-~~-~~~-~~-r~n-j~ofd(-(~pkrl~~~-~~~~~~atd/
SELECT = Access Code 1 - 9 1 -I SPECIAL DIAL = New Access Codes'
from the table below
kcess
Code Features Affected (N/A = Not Affected/Cannot Change)
New
Access
Codes
0 Unused
1
Voice First/Tone First (Dial
1
-N/A) Station LCD Messages (Dial 10-19-N/A)
Door Phones (#151 - #159; #161 - #163) Station Speed Dial Set (Dial 10-49-N/A)
IMDU or RMDS Access (#lQ)
2
Busy Override (Dial 2-N/A) Default Station Numbers and Park Orbits
Do Not Disturb Override (Dial 2-N/A) (R3)200 - 439*
- N/A see Program 04
Off-hook Call Announce (Dial 2-N/A)
3
Executive Override (Dial 3-N/A) External Page Zones 1 - 4 (I#35 - #38)
All Call Voice Page (#30) Group Page (Internal) (#311 - #318)
All Call Voice Page with External Spkrs (#39) Park + Page
Cnf + #331-See Program *05 (R3)
Park Pick Up
#331-See Program ti5 (R3)
Park + Hold
Cnf + #332-See Program *05 (R3)
Park Pick Up #332-See Program M-05 (R3)
4
Automatic Callback (Dial 4-N/A) Flash (Cnf + #45)
CO Line Queuing (Dial 4-N/A) Account Code Input (Cnf + #46)
Station Number Display (#401) T.R. Overridefl. Class Code Input (Cnf + #47)
Port Number Display (#402) BGM Over Stations ON (#481)
Hold (#41) BGM Over Stations OFF (#480)
Hold Pickup (#42)
BGM Over External Speakers ON (#491)(Station
Automatic Busy Redial (Conf + #44)
200 only)
Automatic Busy Redial Cancel (Int + #44) BGM Over External Speakers OFF (#49O)(Station
Message Waiting Answer (#408) from INT,
200
only)
[PDN],
or
[PhDN]
Cancel Message Waiting at Station (#409) from INT,
Display
[PDN], [SDN],
or
[PhDN]
on LCD
[PDN],
or
[PhDN]
(#407)
Access Code/Speed Dial Prefix (44 or #)3
Emergency Call to Attendant Console (#400) Start Trace #489 (Station 200 only)
Stop Trace #488 (Station 200 only)
Cancel Auto Call Back (#43)
DKOO
Notes:
1. The first digit of access codes can replaced by 2 digits. Standard access codes are shown above for reference.
2. The initialized station number sequence of 200 - 439 may not be globally changed through Program 05. Make changes
through Program 04.
3. To store a CO line or feature access code in Speed Dial memory from rotary telephones or telephones without the
Speed Dial and Redial buttons, enter 44 + 7XXX instead of # + 7XxX. 1.
General Notes:
l
Be sure access code changes do not conflict with existing access code or station numbering schemes. Refer to Program
04 - PorVStation Number Assignment.
.
To insert a blank, press programming LED/Button 0 1.
.
If access codes are being changed
to
a
number that is currently assigned,
change the currently assigned code to an
unused code first. In the initialized state, the only unused code is zero (0).
January 1996
10-21