Table of Contents
Advertisement
From the Configuration Menu, use the following command to select the System Menu:
3.
>> Configuration# sys
The System Menu is displayed.
[System Menu]
syslog
sshd
radius
tacacs+
ntp
ssnmp
access
date
time
timezone
olddst
dlight
idle
notice
bannr
hprompt
bootp
dhcp
reminders - Enable/disable Reminders
cur
Enter the following command to set the administrator password:
4.
System# access/user/admpw
Enter the current administrator password at the prompt:
5.
Changing ADMINISTRATOR password; validation required...
Enter current administrator password:
NOTE:
If you forget your administrator password, call your technical support representative for help
using the password fix-up mode.
Enter the new administrator password at the prompt:
6.
Enter new administrator password:
Enter the new administrator password, again, at the prompt:
7.
Re-enter new administrator password:
Apply and save the change by entering the following commands:
8.
System# apply
System# save
-
Syslog Menu
- SSH Server Menu
- RADIUS Authentication Menu
- TACACS+ Authentication Menu
- NTP Server Menu
- System SNMP Menu
- System Access Menu
- Set system date
- Set system time
- Set system timezone (daylight savings)
- Set system DST for US
- Set system daylight savings
- Set timeout for idle CLI sessions
- Set login notice
- Set login banner
- Enable/disable display hostname (sysName) in CLI prompt
- Enable/disable use of BOOTP
- Enable/disable use of DHCP on Mgmt interface
- Display current system-wide parameters
First-time configuration 21
Advertisement
Table of Contents
