Table of Contents
Advertisement
Table 2
User access levels
User account
User
Oper
Admin
NOTE:
With the exception of the admin user, setting the password to an empty value can disable
access to each user level.
Once you enter the administrator password and it is verified, you are given complete access to the
switch.
After logging in, the Main Menu of the CLI is displayed. See the "Menu basics" chapter for a
summary of the Main Menu options.
[Main Menu]
info
stats
cfg
oper
boot
maint
diff
apply
save
revert
exit
>> Main#
Idle timeout
By default, the switch will disconnect the console, Telnet, or SSH session after five minutes of
inactivity. This function is controlled by the idle timeout parameter, which can be set from 1 to 60
minutes. For information on changing this parameter, see the "System configuration" section in the
"Configuration Menu" chapter.
Description and tasks performed
The user has no direct responsibility for switch management. He or she can view all switch
status information and statistics, but cannot make any configuration changes to the switch.
The user account is enabled by default, and the default password is user.
The operator manages all functions of the switch. The operator can reset ports or the entire
switch. By default, the operator account is disabled and has no password.
The super user administrator has complete access to all menus, information, and
configuration commands on the switch, including the ability to change both the user and
administrator passwords. The admin account is enabled by default, and the default
password is admin.
- Information Menu
- Statistics Menu
- Configuration Menu
- Operations Command Menu
- Boot Options Menu
- Maintenance Menu
- Show pending config changes
- Apply pending config changes [global command]
- Save updated config to FLASH [global command]
- Revert pending or applied changes [global command]
- Exit
[global command, always available]
[global command]
Command line interface 12
Advertisement
Table of Contents
