Table of Contents
Advertisement
Table 122
VLAN Configuration Menu options
Command
del
cur
IMPORTANT:
and which is not a member of any other VLAN is automatically added to default VLAN #1. You
cannot remove a port from VLAN #1 if the port has no membership in any other VLAN. Also, you
cannot add a port to more than one VLAN unless the port has VLAN tagging turned on. See the
tag command, in the "Port configuration" section earlier in this chapter.
Protocol VLAN configuration
Command: /cfg/l2/vlan x/pvlan x
[VLAN 1 Protocol 1 Menu]
The following table describes the Protocol VLAN Configuration Menu options.
Table 123
Protocol VLAN Configuration Menu options
Command
pty
<(Ether2|SNAP|LLC)>
<Ethernet type>
protocol
Description
Deletes this VLAN.
Displays the current VLAN configuration.
All ports must belong to at least one VLAN. Any port which is removed from a VLAN
pty
- Set protocol type
protocol - Select a predefined protocol
prio
- Set priority to protocol
add
- Add port to PVLAN
rem
- Remove port from PVLAN
ports
- Add/Remove a list of ports to/from PVLAN
tagpvl
- Enable/Disable port tagging for PVLAN
taglist
- Enable tagging a port list for PVLAN
ena
- Enable protocol
dis
- Disable protocol
del
- Delete protocol
cur
- Display current PVLAN configuration
Description
Configures the frame type and the Ethernet type for the selected protocol.
Ethernet type consists of a 4-digit (16 bit) hex code, such as 0080 (IPv4).
Selects a pre-defined protocol, as follows:
•
•
•
•
•
•
•
•
•
•
•
•
•
decEther2
ipv4Ether2
ipv6Ether2
ipx802.2
ipx802.3
ipxEther2
ipxSnap
netbios
rarpEther2
sna802.2
snaEther2
vinesEther2
xnsEther2
Configuration Menu 153
Advertisement
Table of Contents
