Table of Contents
Advertisement
The following table describes the Gigabit Link Configuration Menu options.
Table 101
Gigabit Link Configuration Menu options
Command
speed 100|10000
mode
fctl rx|tx|both|none
auto on|off
cur
Port ACL/QoS configuration
Command: /cfg/port <port number>/aclqos
[Port 20 ACL Menu]
The following table describes the port ACL/QoS Configuration Menu options.
Table 102
Port ACL/QoS Configuration Menu options
Command
add acl <1-384>| grp <1-384>
rem acl <1-384>| grp <1-384>
cur
Description
Sets the link speed.
All downlink and uplink ports are fixed at 10000 Mbps, and cannot be
changed. Management port 17 is fixed at 100 Mbps.
Sets the operating mode, as follows:
•
Full-duplex
All ports are fixed at full duplex, and cannot be changed.
Sets the flow control. The choices include:
•
Receive (rx) flow control
•
Transmit (tx) flow control
•
Both receive and transmit flow control (default)
•
No flow control
Management port 17 is fixed at both, and cannot be changed.
Enables or disables auto-negotiation for the port.
All downlink and uplink ports are fixed at 10000 Mbps, and cannot be set to
auto-negotiate.
Displays current port parameters.
add
- Add ACL or ACL group to this port
rem
- Remove ACL or ACL group from this port
cur
- Display current ACLs for this port
Description
Assigns an ACL or ACL Group to the port.
Removes an ACL or ACL Group from the port.
Displays current port ACL/QoS parameters.
Configuration Menu 133
Advertisement
Table of Contents
