Table of Contents
Advertisement
Table 121
LACP Port Configuration Menu options
Command
adminkey <1-65535>
cur
VLAN configuration
Command: /cfg/l2/vlan <1-4094>
[VLAN 1 Menu]
The commands in this menu configure VLAN attributes, change the status of the VLAN, delete the
VLAN, and change the port membership of the VLAN.
By default, the VLAN menu option is disabled except VLAN 1, which is always enabled. The HP
10GbE switch supports a maximum of 1,000 VLANs. VLAN 4095 is reserved for switch
management.
NOTE:
See the HP 10Gb Ethernet BL-c Switch Application Guide for information on VLANs.
The following table describes the VLAN Configuration Menu options.
Table 122
VLAN Configuration Menu options
Command
name <1-32 characters>
stg <1-127>
add <port number>
rem <port number>
def <list of port numbers>
ena
dis
Description
Set the admin key for this port. Only ports with the same admin key and
oper key (operational state generated internally) can form a LACP trunk
group.
Displays the current LACP configuration for this port.
name
- Set VLAN name
stg
- Assign VLAN to a Spanning Tree Group
add
- Add port to VLAN
rem
- Remove port from VLAN
def
- Define VLAN as list of ports
ena
- Enable VLAN
dis
- Disable VLAN
del
- Delete VLAN
cur
- Display current VLAN configuration
Description
Assigns a name to the VLAN or changes the existing name. The default
VLAN name is the first one.
Assigns a VLAN to a spanning tree group. If MSTP is used, the range
is 0-32 (0 = CIST).
Adds ports to the VLAN membership.
Removes ports from the VLAN membership.
Defines which ports are members of this VLAN. Every port must be a
member of at least one VLAN. By default, it defines ports to VLAN 1.
Enables this VLAN.
Disables this VLAN without removing it from the configuration.
Configuration Menu 152
Advertisement
Table of Contents
