Table of Contents
Advertisement
Table 111
CIST Port Configuration Menu options
Command
edge disable|enable
on
off
cur
Spanning Tree configuration
Command: /cfg/l2/stp <1-128>
[Spanning Tree Group 1 Menu]
The HP 10GbE switch supports the IEEE 802.1D Spanning Tree Protocol (STP) and Cisco proprietary
PVST and PVST+ protocols. You can configure up to 127 spanning tree groups on the switch (STG
128 is reserved for switch management). Spanning Tree is turned on by default.
NOTE:
When RSTP is turned on, only STP group 1 can be configured.
The following table describes the Spanning Tree Configuration Menu options.
Table 112
Spanning Tree Configuration Menu options
Command
brg
port <port number>
add <1-4094>
remove <1-4094>
clear
on
off
default
Description
Enables or disables this port as an edge port. An edge port is not
connected to a bridge, and can begin forwarding traffic as soon as the link
is up. Configure server ports as edge ports (enabled). This command is
disabled by default.
Enables CIST on the port.
Disables CIST on the port.
Displays the current CIST port configuration.
brg
- Bridge parameter menu
port
- Port parameter menu
add
- Add VLAN(s) to Spanning Tree Group
remove
- Remove VLAN(s) from Spanning Tree Group
clear
- Remove all VLANs from Spanning Tree Group
on
- Globally turn Spanning Tree ON
off
- Globally turn Spanning Tree OFF
default - Default Spanning Tree and Member parameters
cur
- Display current bridge parameters
Description
Displays the Bridge Spanning Tree Menu.
Displays the Spanning Tree Port Menu.
Associates a VLAN with a spanning tree and requires an external VLAN ID as a
parameter.
Breaks the association between a VLAN and a spanning tree and requires an
external VLAN ID as a parameter.
Removes all VLANs from a spanning tree.
Globally enables Spanning Tree Protocol.
Globally disables Spanning Tree Protocol.
Restores a spanning tree instance to its default configuration.
Configuration Menu 144
Advertisement
Table of Contents
