Projector Power On/Standby - Sony SRP-X500P System Integration Manual

PROJECTOR POWER ON/STANDBY (1)

The following is an example of controlling PROJECTOR
POWER ON/STANDBY using a toggle switch.
I Setting
1. Connect a toggle switch to INPUT 1 of the PARALLEL
REMOTE connector on the SRP-X500P.
2. Select PROJECTOR POWER ON/STANDBY on the
PARALLEL/PROJECTOR CONTROL screen. This
selection appears on a drop-down list on INPUT 1
(Fig. 4).
I Status
The relationship between the switch position and the
projector power status is as follows (Fig. 5):
- Pressing the switch once turns on projector power.
- Pressing the switch once again sets projector power to
standby mode.
Fig. 4 PARALLEL/PROJECTOR CONTROL Screen
Press switch once
Fig. 5 Projector POWER ON/STANDBY Status
PROJECTOR POWER ON/STANDBY (2)
The following is another example of controlling PROJECTOR
POWER ON/STANDBY using two push switches.
I Setting
1. Connect two push switches to INPUT 1 and INPUT 2
of the PARALLEL REMOTE connector on the
SRP-X500P.
2. Select PROJECTOR POWER ON on the
PARALLEL/PROJECTOR CONTROL screen. This
selection appears on a drop-down list on INPUT 1.
Then select PROJECTOR POWER STANDBY on the
PARALLEL/PROJECTOR CONTROL screen. This
selection appears on a drop-down list on INPUT 2
(Fig. 6).
I Status
The relationship between the switches and the projector
power status is as follows (Fig. 7):
- Pressing the switch assigned to INPUT 1 turns on
projector power.
- Pressing the switch assigned to INPUT 2 sets projector
power to standby mode.
Fig. 6 PARALLEL/PROJECTOR CONTROL Screen
INPUT 1
(PROJECTOR
Press switch again
POWER ON)
INPUT 2
(PROJECTOR
POWER STANDBY)
Projector
Power
Fig. 7 Switch and Projector Power ON/STANDBY Status
5
Setting up the SRP-X500P Using Manager Software
Press switch
Press switch
17