Specifications; Dimensions - Sony SRP-X500P System Integration Manual

Specifications

SRP-X500P
General
Power requirements AC 120 V, 60 Hz (for the U.S.A and Canada)
AC 220 V, 50/60 Hz (for China)
AC 230 V, 50/60 Hz (for other countries)
Power consumption 120 W
Operating temperature +32 to +104 °F (0 to +40 °C)
Storage temperature -4 to +140 °F (-20 to +60 °C)
Dimensions (W x H x D) 19 x 5 1/4 x 14 inches (482 x 132 x 357 mm)
Weight Approx. 26 lb 3 oz (12 kg)
Supplied accessories AC power cord (1), operation manual (1), foot (4),
SRP-X500P Manager Software CD-ROM (1), antenna (2)
Electrical characteristics
Composite video
Color system NTSC/PAL/SECAM
Frequency response 50 Hz to 10 MHz
Level 1.0 Vp-p (75 )
Component video
Color system NTSC/PAL
Frequency response 50 Hz to 150 MHz
Level Y: 1.0 Vp-p (75 ), R-Y/B-Y: 0.7 Vp-p (75 )
RGB
Frequency response 50 Hz to 150 MHz
Resolution SXGA: 1280 x 1024 pixels, 60 Hz,
supporting 480p/1080i
Level R/G/B: 0.7 Vp-p (75 ), Sync/HD, VD: 1 to 5 Vp-p
(47 k ) sync positive/negative
Audio (analog)
Frequency response Line input to Line output: 20 Hz to 20 kHz ±0.5 dB
(1 kHz reference)
T.H.D. Line input to Line output: Less than 0.01% (1 kHz)
S/N ratio Line input to Line output: More than 94 dB (IHF A)
Crosstalk Line input to Line output: Less than -80 dB (1 kHz)
Others
Antenna in (a/b) BNC x2, DC +9 V out
Microphone power supply DC +48 V, MIC 1 to 4 inputs

Dimensions

19 (482)
482 (19)
430 (17) 17 (430)
Sony Electronics Inc.
1 Sony Drive
Park Ridge, NJ 07656
www.sony.com/proaudio
A-1155
MK10375V1
Audio inputs
Input
MIC/WL 1, 2 XLR-3-31 type Balanced
MIC 3, 4
LINE
AV/RGB (A to E) Phono x 2
Audio output
Output
LINE 1 to 4
Speaker outputs
Output
CH1/CH2
CH3/CH4 (70V LINE) Screw-type binding terminal x 4
* The same power rating can be acquired for both 8
Connect the speakers so the total speaker impedance is 4
AV/RGB inputs
Input
VIDEO (A to C)
COMPONENT/RGB (D, E)
AV/RGB outputs
Output
VIDEO
COMPONENT/RGB
Remote control terminal
RS-232C ports
PROJECTOR CONTROL D-sub 9-pin (male)
REMOTE
Parallel I/O ports Connector
PARALLEL IN
PARALLEL OUT
Control S ports
PROJECTOR IN*
PROJECTOR OUT* Mini jack
* For the VPL-PX15 LCD data projector only
132 (5 1/4)
5 1/4 (132)
Unit: inches (mm)
Connector Circuit Channel Reference/peak level
Mono -60 to -30 dBu/-37 to -7 dBu More than 2.2 kΩ
XLR-3-31 type Balanced Mono -60 to -30 dBu/-37 to -7 dBu More than 2.2 kΩ
Phono x 2 Unbalanced Stereo -30 to 0 dBu/+10 dBu
Unbalanced Stereo -30 to 0 dBu/+10 dBu
Connector Circuit Channel Reference/peak level
Phono x 1 Unbalanced Mono -5 dBu/+15 dBu
Connector Speaker impedance
4 to 16 Ω
Screw-type binding terminal x 4
4 to 16 Ω (at low impedance) 50 W (4 , 8 )*
82 to 10 kΩ (at 70 V LINE)
Connector Signal type
Phono x 1 Composite
D-sub 15-pin Component/RGB
Connector Signal type
Phono x 1 Composite
D-sub 15-pin Component/RGB
Connector Function
Input selection, Power on/standby
D-sub 9-pin (male) Setting of SRP-X500P audio and switch functions
from a PC running the SRP-X500P Manager software
Function
D-sub 25 pin (female) AV selection, Power on/off, Scene recall, Make-contact
Volume, Volume up/down, Muting
Output status of Parallel input function
Connector Function
Mini jack For the connection of projector remote commander
Input selection, Power on/standby
©2006 Sony Electronics Inc. All rights reserved.
Reproduction in whole or in part without written permission is prohibited.
Non-metric weights and measurements are approximate.
Features, design and specifications are subject to change without notice.
Impedance
More than 10 kΩ
More than 10 kΩ
Load impedance
More than 10 kΩ
Rated power
90 W (4 , 8 )*
60 W (82 )
and 4 speaker impedance.
or higher.
Type
CMOS level,
active low
Open collector
Sony is a trademark of Sony.
Printed in USA 11/06