Sony SRP-X500P System Integration Manual page 9

5
REMOTE RS-232C connector
(D-sub, 9-pin, male)
This is an RS-232C serial connector for
remote control. When a PC is
connected, parameters can be set using
the SRP-X500P Manager software. The
SRP-X500P can be controlled from the
external controller connected to the
REMOTE RS-232C connector.
6
OUTPUT connector section
These connectors output the video
signal input from the AV/RGB INPUT
video connectors. Signal format
conversion is not carried out.
COMPONENT/RGB connector
(HD D-sub, 15-pin, female): Outputs
component or RGB signals.
VIDEO connector (phono jack):
Outputs composite signals.
7
SPEAKERS CH terminals (1 to 4)
(screw terminal)
These are the output terminals of the
internal power amplifiers. For more
details, refer to Connecting High-
impedance Speakers/Low-impedance
Speakers in the appendix.
8
CIRCUIT BREAKER button
The circuit breaker cuts off the main
power when excessive current flows
through the AC IN connector. If the
circuit breaker trips, press the CIRCUIT
BREAKER button to reset the breaker,
but do not use the SRP-X500P. Instead,
turn it off and contact the Sony dealer
from whom you purchased the unit.
9
AC IN connector
Connects the supplied AC power cord.
!º
LINE OUTPUT connectors (1 to 4)
(phono jack)
Connect to the line input connectors of
a power amplifier, CD/MD recorder, etc.
The LINE OUTPUT 3/4 is set to REC OUT
in factory default settings. SRP-X500P
Manager software settings can be
changed in order to use LINE OUTPUT
3/4 connectors for other purposes.
!¡
AV/RGB INPUT audio connectors
(A to E) (phono jack)
Connect to the audio output connectors
of devices with video output connection
to SRP-X500P !¢ AV/RGB INPUT video
connectors. When connecting a device,
be sure that each output connector on
the device is connected to the AV/RGB
INPUT video and audio connector on
the SRP-X500P with the corresponding
letter (A to E).
3
!™
LINE IN connectors (phono jack)
Connect to the line output connectors
of a CD player, MD recorder, etc.
!£
MIC INPUT connectors (1 to 4)
(XLR-3-31-type)
Connect wired microphones. When
wired microphones are connected to
the MIC INPUT 1/2 connectors, input
signals from the wireless microphones
take priority from the moment the
tuner units begin receiving the signal.
!¢
AV/RGB INPUT video connectors
(A to C: phono jack; D and E:
HD D-sub, 15-pin, female)
Connect to the video output connectors
of devices with audio output connection
to SRP-X500P !¡ AV/RGB INPUT audio
connectors. When connecting a device,
be sure that each output connector on
the device is connected to the AV/RGB
INPUT video and audio connector on
the SRP-X500P with the corresponding
letter (A to E).
Panel View
9