Controls; Projector Control Rs-232C Connector - Sony SRP-X500P Operating Instructions Manual

BACK REDUCER button to cancel the procedure,
turn down the SPEAKER OUT control, then try
again.
• Do not make a noise while the SRP-X500P is
scanning the frequency bands, as this may cause
error in detection.
• When you use the AGC (automatic gain control)
function, do the setting by using the SRP-X500P
Manager software before performing the procedure
above.
24

Controls

Controls
This section explains how to use the control connectors on
the SRP-X500P and how to program an optional
programmable remote commander with the functions of
the SRP-X500P.
Note
Production of some of the peripherals and related devices
described in this chapter has been discontinued. For advice
about choosing devices, please contact your Sony dealer or
a Sony sales representative.
PROJECTOR CONTROL RS-232C
connector
The PROJECTOR CONTROL RS-232C connector can be
used to control a projector or display monitor equipped
with an RS-232C connector.
When the SRP-X500P is connected to a projector or
monitor through the PROJECTOR CONTROL RS-232C
connector, the power status (on or standby) and input
signal selection of the projector or monitor are linked to
those of the SRP-X500P.
Set the PROJECTOR PROTOCOL selector in accordance
with the model of the projector or monitor, as indicated in
the following table.
The format of the video signal output to the
COMPONENT/RGB connector is factory-set to RGB
format. To change the setting, refer to the SRP-X500P
Manager User's Guide.
Product model PROJECTOR
PROTOCOL
selector setting
VPL-FH300/ 1
FW300
VPL-FE40/FX40 2
VPL-CW125 3
VPL-CX100 series 4
VPL-EW5/EX50/ 5
EX5
VPL-FX52 6
GXD-L52H1 7
FWD-50PX3 8
Not applicable 9, B-F
RGB input
connector on the
projector or
monitor
INPUT C
INPUT C
INPUT A
INPUT A
INPUT A
INPUT C
RGB/COMPONENT
RGB/COMPONENT
-