Connecting High-Impedance Speakers/Low-Impedance Speakers; Programming A Learning-Type Remote Commander - Sony SRP-X500P System Integration Manual

Connecting High-impedance Speakers
High-impedance speakers have the following features:
• Multiple speakers can be connected (see table below)
• Extended cable lengths, due to low cable loss
The maximum number of high-impedance speakers that
can be connected depends on impedance levels:
Impedance of Power of speaker
speaker
1 kΩ 5 W
3.3 kΩ 1.5 W
10 kΩ 0.5 W
Wiring of high-impedance speakers
Connect high-impedance speakers to the + terminal of the
SP3 and SP4. Before making these connections, set the
SP3 and SP4 outputs to 70V Line.
SP-3 +
SP-3 -
+ -
SP-4 +
+
SP-4 -
Connecting Low-impedance Speakers
The SRP-X500P can drive eight 8 Ω speakers (two 8 Ω
speakers can be connected to each SPEAKER OUTPUT).
Parallel connection is required. (Serial connection is not
S
recommended.)
8 ohm 8 ohm
SP-1 +
SP-1 -
8 ohm 8 ohm
SP-2 +
SP-2 -
Connectable number of
speaker
12
40
120
+ -
8 ohm 8 ohm
SP-3 +
SP-3 -
8 ohm 8 ohm
SP-4 +
SP-4 -
Programming a Learning-type Remote
Commander
Commands that control the SRP-X500P functions can be
stored in an optional programmable learning-type IR
remote commander with the following functions:
• AV/RGB SELECT buttons
• PROJECTOR POWER switch
• MASTER volume control
Turning up the volume
Turning down the volume
Muting the volume
For details of how to program your remote commander, please refer to its
supplied operation manual.
1. Hold down the IR OUTPUT MODE button for two
seconds or more. The button lights up green and the
remote emitter/sensor lights up red when the SRP-X500P
is ready to emit commands from the remote emitter/
sensor. Note that no audio/video is output from the
SRP-X500P during this time.
2. Operate the SRP-X500P function to be programmed to
the remote commander as follows:
To program the function of the AV/RGB SELECT
buttons
Press the AV/RGB SELECT button to be programmed to
the remote commander so that it lights up.
To program the function of the PROJECTOR POWER
switch
Press the PROJECTOR POWER switch so that it lights up.
To program the function for turning up the
MASTER volume
Rotate the MASTER control to the 11 o'clock position so
that the MASTER MUTING indicator lights up.
To program the function for turning down the
MASTER volume
Rotate the MASTER control to the 9 o'fclock position so
that the MASTER MUTING indicator lights up.
To program the function for muting the MASTER
volume
Rotate the MASTER control to the infinity position so
that the MASTER MUTING indicator lights up.
6
Appendix
27