Panel View; Front Panel - Sony SRP-X500P System Integration Manual

SRP-X500P System Integration Guide
3

Panel View

3-1. Front Panel

1 2
!• !¶
1
POWER switch
Turns the SRP-X500P on and off.
With the SRP-X500P Manager software,
you can link projector or display monitor
power on/standby control to that of the
SRP-X500P. For more details, refer to
the Projector Control section (5-4.).
2
EMG (emergency) indicator
Lights up red when an emergency
broadcast system connected to the
REMOTE PARALLEL connector cuts the
SPEAKER and LINE outputs.
3
Wireless microphone slots
(WL1/WL2)
Accommodates up to two WRU-806A/
806B (not supplied) or URX-X1 tuner
module (not supplied) included in the
UWP-X1/X2.
4
Remote emitter/sensor
Point an optional remote commander
towards the emitter/sensor. Using an
optional learning-type IR remote
controller, you can wirelessly control
frequently accessed SRP-X500P and
connected projector operations. For
6
3 4 5
!§ !∞ !¢
more details, refer to Programming a
Learning-type Remote Commander in
the appendix.
5
Input level controls
Rotate to adjust the input signal level:
MIC1/WL1: Adjusts the level of the
signal input from the MIC INPUT 1
connector or the tuner unit installed in
the WL1 slot.
MIC2/WL2: Adjusts the level of the
signal input from the MIC INPUT 2
connector or the tuner unit installed in
the WL2 slot.
MIC3: Adjusts the level of the signal
input from the MIC INPUT 3 connector.
MIC4: Adjusts the level of the signal
input from the MIC INPUT 4 connector.
LINE: Adjusts the level of the signals
input from the LINE IN connectors.
AV/RGB: Adjusts the level of the
signals input from the AV/RGB INPUT
audio connectors, as specified by the 0
AV/RGB SELECT buttons.
6
Input indicators
SIGNAL (signal level) indicators:
Lights up green when the signal is
6
!£ !™ !¡
input from each audio connector.
RF (radio frequency) indicators:
Lights up green when the level of the
RF signal input from each tuner unit is
satisfactory.
AF (audio frequency) indicators:
Light up yellow when the signal is input
from each tuner unit.
7
PROTECTION (protection circuit)
indicator: Lights up red when the
protection circuit of the internal power
amplifier is activated.
CLIP (clip) indicators: Lights up red
when the output level of the internal
power amplifier is excessive and the
output signal is distorted.
70V LINE (high-impedance speaker
connection) indicator: Lights up
green when the SPEAKERS CH-3/4
terminals are set to connect high-
impedance speakers (70V LINE).
VU (volume unit) meters: Uses five-
segment LEDs to indicate the signal
output level prior to adjustment by the
!™ SPEAKER OUT controls.
7
!º 9 8
SPEAKER OUTPUT indicators