Bosch DB18C3100R2 Installation Manual page 70

70 en | Default Configuration
5
6
7
8
9
10
F.01U.033.308 | V7 | 2009.09
Pre-alarm time [sec.]:
Alarm recording
Stream
Audio
Post-alarm time [secs.]:
Continuous recording
Stream
Audio
Delete old video
Older than [days]:
Delete protected data:
Default settings
Copy settings to other
time periods...
Save
Installation Guide
Select the pre-alarm time for the alarm and motion
recording.
Note:
The maximum pre-alarm time is 1800 seconds. The pre-
alarm time depends on the recording rate of the MPEG4
device's pre-alarm recording. A maximum of 3600 images
can be recorded for each pre-alarm and by each camera.
Make the settings for alarm recording.
Select the stream for the MPEG4 device (Stream 1 or
Stream 2).
Activate this check box if audio is also to be recorded.
Enter the post-alarm time.
Note:
The maximum post-alarm time is 999 seconds. The default
setting is 0 seconds.
Make the settings for continuous recording.
Select the stream for the MPEG4 device (Stream 1 or
Stream 2).
Activate this check box if audio is also to be recorded.
Activate this check box to automatically delete data after a
specified number of days.
Enter the number of days after which data should be
deleted.
Example: 3 means that all data older than 3 days is
automatically deleted.
Check box is activated: Protected data is automatically
deleted after a specified number of days.
Check box is not activated: protected data is not
automatically deleted.
Click the button to see the default settings.
Copies all tabs from the selected time period with all the
settings they contain into other time periods.
Click the button. A dialog box opens where you can select
the time periods.
The entries are saved.
DiBos/DiBos Micro
Bosch Sicherheitssysteme GmbH