Online - Yamaha DME Designer Owner's Manual

Online

You can connect the DME unit to your computer and transfer configurations, scenes and parameters
created in DME Designer into the DME unit. You can also read data from the DME unit into DME
Designer, synchronizing it with the status of the DME unit.
Because Synchronization presupposes that the DME unit can communicate with the computer where
DME Designer is installed, the necessary drivers (USB-MIDI or DME-N Network Driver) must be
installed, and appropriate settings must be made for each driver and for DME Designer MIDI port.
NOTE
Because there are no scene settings when the DME unit is purchased, the configuration and scene information created in
DME Designer must first be transferred.
1
DME Unit and Computer Connection.
Connect the DME unit and computer using a USB cable or an Ethernet cable.
See separate "DME64N/24N Owner's Manual" for details.
2
MIDI Driver Installation.
Install the USB-MIDI driver or DME-N Network driver in the computer.
See separate "DME Designer Installation Guide" for details.
3
MIDI Driver Setup.
Make the necessary settings for the MIDI driver installed in the computer. If the driver is set up
already, check the settings before going online.
See separate "DME Designer Installation Guide" for details.
4
MIDI Driver Port Setup.
The MIDI Setup dialog will be displayed if you press the MIDI Setup button on the MIDI Setup
toolbar that is displayed when you start DME Designer Set up the In/Out/Thru ports connected to
the DME.
5
Making MIDI IN/OUT Settings in DME Designer.
On the [Port] tab of the "MIDI" dialog box, select the MIDI driver used for sending and receiving
MIDI messages. If the driver is set up already, check the settings before going online.
"MIDI" [Port] tab (page 97)
Chapter 2 DME Designer Overview
DME Designer Owner's Manual 35