HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual page 214

POST Error Messages
Table C-9: 800 Series POST Error Messages
Error Code
806-NVRAM has
been reset
Please power off the
system and restore
SW1.2 to the default
position. Run BIOS
Setup to set default
values.
System Halted.
C-34
Audible Probable Source of
Beeps Problem
None The system configuration
switch (SW1), position 2
has been turned on and
the system configuration
data has been cleared
from CMOS. This switch
must be returned to the
default off position for
normal operation and to
save configuration setup
data.
The system must be
reconfigured.
continued
Action
1.
2.
3.
4.
5.
6.
7.
8.
HP Servers Troubleshooting Guide
Remove power from the
system.
Locate the system
configuration switch
(SW1). Refer to your
server-specific user
documentation for
instructions.
Return position 2 to the
off position.
Restart the system.
Press the F10 key to run
the server setup utility
and configure the
system.
Select the primary
operating system.
Set the date and time.
Complete additional
configuration as needed.
continued