Network Installation - D-Link NetDefend DFL-CP310 User Manual

Network Installation

1. Verify that you have the correct cable type.
For information, see Network Requirements.
2. Connect the LAN cable:
• Connect one en
of the unit.
• Connect the other end to PCs, hubs, or other network device
3 . Connect the WAN cable:
• Connect one end of the Ethernet cable to the WAN port at the
unit.
• Connect the other end of the cable to a Cable Modem, xDSL modem or
office network.
4. Connect the power adapter to the power socket, labeled
NetDefend firewall.
5. Plug the power adapter into the wall electrical outlet.
Warning: The NetDefend firewall power adapter is compatible with either 100, 120 or
230 VAC input power. Verify that the wall outlet vo
voltage specified on your po
in injuries or damage to equip
Figure 8: Typical Connection Diagram
Chapter 2: Installing and Setting up the NetDefend firewall
d of the Ethernet cable to one of the LAN ports at the back
wer adapter. Failure to observe this
ment.

Network Installation

s.
back of the
PWR, at the back of the
ltage is compatible with the
warning may result
35