Yamaha DM1000 Owner's Manual page 303

REV+FLANGE
One input, two output reverb and flanger effects in parallel.
Parameter
REV TIME 0.3–99.0 s
INI. DLY 0.0–500.0 ms
HI. RATIO 0.1–1.0
DIFF. 0–10
DENSITY 0–100%
HPF THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
LPF 50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
REV/FLG 0–100%
FREQ. 0.05–40.00 Hz
DEPTH 0–100%
MOD. DLY 0.0–500.0 ms
FB. GAIN –99 to +99%
WAVE Sine, Tri
SYNC OFF, ON
1
NOTE
1.
REV->FLANGE
One input, two output reverb and flanger effects in series.
Parameter
REV TIME 0.3–99.0 s
INI. DLY 0.0–500.0 ms
HI. RATIO 0.1–1.0
DIFF. 0–10
DENSITY 0–100%
HPF THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
LPF 50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
REV.BAL 0–100%
FREQ. 0.05–40.00 Hz
DEPTH 0–100%
MOD. DLY 0.0–500.0 ms
FB. GAIN –99 to +99%
WAVE Sine, Tri
SYNC OFF, ON
1
NOTE
1.
Range
Reverb time
Initial delay before reverb begins
High-frequency reverb time ratio
Spread
Reverb density
Reverb and flange balance (0% = all reverb, 100% = all
flange)
Modulation speed
Modulation depth
Modulation delay time
Feedback gain (plus values for normal-phase feedback,
minus values for reverse-phase feedback)
Modulation waveform
Tempo parameter sync on/off
Used in conjunction with TEMPO to determine FREQ.
Range
Reverb time
Initial delay before reverb begins
High-frequency reverb time ratio
Spread
Reverb density
Reverb and flanged reverb balance (0% = all flanged reverb,
100% = all reverb)
Modulation speed
Modulation depth
Modulation delay time
Feedback gain (plus values for normal-phase feedback,
minus values for reverse-phase feedback)
Modulation waveform
Tempo parameter sync on/off
Used in conjunction with TEMPO to determine FREQ.
Effects Parameters
Description
Description
DM1000—Owner's Manual
303