Muting Channels; Panning Channels; Soloing Channels - Yamaha DM1000 Owner's Manual

Muting Channels

To mute Pro Tools channels, press the [ON] buttons. The [ON] button indicators of muted
channels turn off. Grouped channels are muted together.
Press the [ON] buttons again to unmute channels. The [ON] button indicators of unmuted
channels light up.
There are two mute modes in Pro Tools: Implicit mute and Explicit mute. You can check the
mute mode by viewing the [ON] button indicators.
• Implicit mute................This is a forced mute mode in which the channels are muted
• Explicit mute ................In this mode, the channels are muted or turned off manually.

Panning Channels

You can adjust the Pro Tools channel pan settings.
1 Press the ENCODER MODE [PAN] button.
2 Press the [F2] button to select Channel Display mode.
On a Channel Display mode page, parameter controls 1–16 indicate the pan settings.
3 For stereo channel pan settings, press the [PAN] button again. The button
indicator flashes.
Pressing the [PAN] button repeatedly toggles between the left and right panpots. When the
left panpot is active, the SELECT ASSIGN parameter of the display indicates "Pan." When
the right panpot is active, the SELECT ASSIGN parameter indicates "PanR."
4 Turn the Encoders to pan the channels.
Press and hold down the [AUX 6] button and press the desired Encoder push-switch to reset
the corresponding channel panpot to center.

Soloing Channels

To solo Pro Tools channels, press the [SOLO] buttons of the desired channels. Grouped
channels are soloed together, and other channels are muted.
Press the [SOLO] buttons again to unsolo the channels.
Configuring Sends A–E as Pre or Post
You can set Pro Tools channels for the selected Sends (A–E) to pre or post.
1 Press the AUX SELECT [AUX 1]–[AUX 5] buttons to select the desired Sends
(A–E).
The selected button indicators light up. Send pre/post status can be viewed in Channel Dis-
play or Meter Display mode by pressing and holding down the [AUX1]–[AUX5] buttons.
2 Press the Encoder push-switches for the desired channels.
Pressing the Encoder push-switches repeatedly toggles between pre and post.
You can set Sends as pre or post by pressing the Encoder push-switches if faders, Encoders,
and [ON] buttons are in Flip mode. See page 218 for more information.
Pro Tools Remote Layer
because other channels are soloed. In this mode, the [ON] but-
ton indicators flash.
In this mode, the [ON] button indicators turn off.
217
DM1000—Owner's Manual
17