Fader1 &2 Pages - Yamaha DM1000 Owner's Manual

196
Chapter 16—Automix
K
PROTECT ON/OFF
To protect the contents of the Automix memory selected in the MEMORY TITLE col-
umn, move the cursor to this button and press [ENTER]. A padlock icon (
next to the titles of Automix memories that are write-protected. You cannot store, clear,
or edit the title of write-protected Automix memories.
For details on the Store, Recall, Title Edit, and Clear functions, see "General Library
Operation" on page 165.
Fader1 &2 pages
The Fader1 & 2 pages enable you to edit fader positions while viewing the current fader
position and the fader data recorded in the Automix.
To locate the Fader1 or 2 page, press the DISPLAY ACCESS [AUTOMIX] button repeatedly
until the page appears.
During Automix playback, fader positions are displayed graphically as black bars on the
Automix | Fader1 or 2 page. The Fader1 page displays fader positions for Input Channel 1
through 48 and Stereo out. The Fader2 page displays fader positions for Bus Outs 1–8 and
Aux Outs 1–8.
When the Fader mode is set to Fader, each page displays Input and Output Channel levels.
When the Fader mode is set to Aux, each page displays Aux Send levels.
During rerecording, the Fader1 and 2 pages display the existing
fader data in bar graphs. While fader events are being recorded,
arrows appear next to each fader bar. A downward arrow indi-
cates that the current fader position is higher than that specified
by the existing fader data. An upward arrow indicates that the
current fader position is lower than that specified by the existing
fader data.
A
ABSOLUTE & RELATIVE
These buttons are the same as those on the Main page (see page 191).
B
MOTOR
This button turns the fader motors on or off for Automix playback. The button is high-
lighted when the motors are on.
Tip: You cannot turn off the motors during Automix recording. Even if this button is turned
off, the motors are automatically turned on when recording starts.
DM1000—Owner's Manual
3
4 5
1 2
6
) appears