Toro Reelmaster 7000-D Operator's Manual page 27

Installing the Hose Guide (continued)
1. If the hairpin
the compensation-spring rod, remove the
hairpin and insert it in the hole next to the
bracket.
2. Remove the 2 flange locknuts (3/8 inch)
and 2 carriage bolts (3/8 x 1-1/4 inches)
that secure the turf-compensator bracket
the cutting-unit frame.
3. Align the studs
the holes in the cutting-unit frame and the turf-
compensator bracket
Note:
guide aligns toward the center
machine.
4. Assemble the hose guide and turf-
compensator bracket to the cutting-unit frame
with the 2 flange locknuts (3/8 inch)
5. Torque the locknuts to 37 to 45 N∙m (27 to 33
ft-lb).
3466-702A
is installed in the rear hole of
of the right hose guide with
.
Ensure that the support loop of the hose
G410292
to
G410293
of the
.
G410311
Page 3–5 Setup: Installing the Cutting Units