Replacing The Hydraulic Filters - Toro Reelmaster 7000-D Operator's Manual

Checking the Hydraulic-Fluid Level (continued)
3. Remove the hydraulic-tank cap
tank.
4. Remove the dipstick
wipe it with a clean rag.
5. Insert the dipstick into the filler neck; then
remove it and check the fluid level.
The correct hydraulic-fluid level is between the
full mark
dipstick.
6. If the level is low, add the specified hydraulic
fluid to raise the fluid level to the full mark.
7. Install the dipstick and hydraulic-tank cap to
the tank.

Replacing the Hydraulic Filters

Use the following Toro hydraulic filters:
Name
Return filter
Charge filter
Using another type of filter may void the warranty on some components.
Changing the Charge Filter
1. Prepare the machine for maintenance.
2. Tilt the seat.
Maintenance: Hydraulic System Maintenance
from the filler neck and
and the add mark
Toro Part No.
94-2621
75-1310
Page 6–46
from the
on the
G425419
IMPORTANT
Location
Below the right frame channel.
Under the seat plate.
3466-702 A