Table of Contents
Advertisement
7-7-5. Set Up Level Adjustment
1) Press the [MIX] button in the MIX SELECT block.
2) Press the [BLACK] button in the MIX SELECT block.
3) Turn the [MANUAL MIX ] lever to the opposite side.
4)
The display turns black.
5) Press the [4 ] button in the PROGRAM MEMORY block.
6)
Adjust SET UP to 0% with the [A] and |V| buttons.
SET UP to 0%
ae:
|
I
Fig. 7-3.
7-7-6. White Fade Adjustment
Adjusting method
1)
Press the [3 ] button in the PROGRAM MEMORY block.
2)
Press the | WHITE | button in the MIX SELECT block.
3)
Adjust the white level to 100% with the [A] and [V] buttons.
White level 100%
(700 mv)
Fig. 7-4.
7-7-7. H Center Adjustment
(Horizontal position adjustment of LINE A and
LINE B)
Adjusting method:
1) Press =
in the WIPE SELECT block.
2) Set the [MANUAL MIX] lever to the center.
3) Press the
[LUMINANCE]
and
[HCENTER]
buttons of
LINE A.
4)
Press the same buttons of LINE B.
5)
Adjust any difference in position to the minimum with the
<] and [>] buttons.
>| |<.
|
This horizontal difference
must be minimum.
Fig. 7-5.
7-7-8. Write Y Level Balance Adjustment
* This adjustment needs the S video RAMP signal.
Adjusting method:
1) LINE A-RAMP(S)
2) LINE B-RAMP (8)
3) Press Ml in the WIPE SELECT block.
Move the [ MANUAL MIX ] lever to the center.
4)
Press the [ BIT DEFECT | button three times.
(The coarsest bit defect is selected.)
5) Press the| 9 | button.
L
sl >|
Fig, 7-6.
Align the vertical line at the upper right end with the line
below using the [<] and
Note:
If there is no RAMP signal, do not adjust this.
—168-
Advertisement
Table of Contents
