Table of Contents
Advertisement
—pl-
12
Connec!
Connecting an Editing Control
Connect an editing controller to the GPI INPUT jack on the
fear panel. Use a proper connecting cable forthe
equipment,
xv.on 1000 (Rear)
Video editing controler such as AM E5001E700
2S : Signal tow
the AC-Power Cord. -
'Connect the contra! unit to the CONTROL UNIT jack on the
front panel. Then connect the AC power cord to a wall
outet
nection Ei — Connecting the Control Unit and
Towal out
AC power cord
Controt unt
'CONTROL UNIT
Connect the pg wih tbe
arrow mark (facing up,
In this chapter, we explain from turning on the power to switching the images.
Basic Switching Operation
Switching Operation
'You can switch the images basically as described below.
'You can select a particular signal (page 16) and switching
ettect (page 17)
—
Press the POWER switch to turn on the
power.
2 Play back the tapes.
Move the switching lever up or down.
'The mages switches withthe overlap effect.
13
Advertisement
Table of Contents
