GE Amersham Imager 680 Operating Instructions Manual page 82

4 Installation
4.3 System settings
4.3.2 Focus
Part
10
Adjust focus
Step
1
2
3
4
5
6
82
Function
Cancel button: Use the button to leave the view without saving changes.
Action
Prepare and place a sample on a tray and place the tray in the instrument's
upper or lower tray position.
If relevant, point to an area of interest to zoom in on.
Adjust the brightness of the image to a satisfactory level by using the plus
and minus buttons next to the Brightness value.
Adjust the focus to a satisfactory level by using the arrows above and below
the Focus value.
Select OK to save the settings.
Note:
Cancel will close the view without saving changes.
The new focus will be available for captures until a new capturing method
is selected, or until the instrument enters standby mode.
Prior to the capture confirm the use of the new focus with Yes. Selecting the
No button cancels the adjustments to focus and the normal fixed focus
setting (default) is once again in use.
CAUTION
Do not put your hand into the upper tray position. The gap is small
and you may injure your hand.
Amersham Imager 680 Operating Instructions 29271308 AB