Integrus Charging Units - Bosch Integrus Installation And Operation Manual

72 en | Operation
The test mode is deactivated when the receiver is switched off.
9.4

Integrus Charging Units

Ensure that the charging unit is connected to the mains and that it is switched on. Place the
receivers firmly in the charging compartments. The charging indicator LEDs on all receivers
should illuminate. These LEDs indicate the charging status of each receiver:
LED color
Green
Red
Red blinking
Off
NOTICE!
–
–
–
–
–
–
IOM-INT | V1.1 | 2010.12
Charging status
Charging completed.
Charging in progress.
Error status. See chapter 6, Trouble-shooting.
Charger switched off or receiver not properly inserted.
These charging units are only intended to charge LBB 4540 receivers with a LBB 4550/00
battery pack. You cannot charge other receiver types with the LBB 4560 charging units,
nor can you use other charging units to charge LBB 4540 receivers.
It is preferred to switch on the charging unit before inserting the receivers. Receivers can
be inserted or removed without damage while the charging unit is switched on.
Charge the battery pack to full capacity before using them for the first time.
The charger always applies fast charge during the first 10 minutes after inserting a
receiver. Inserting the receiver multiple times with a fully charged battery pack should
therefore be avoided, as this will damage the battery pack.
Continuously charging the receiver will not damage the receiver or battery pack.
Receivers can therefore safely be left in their charging positions when they are not used.
When the rechargeable battery pack is used, it is advisable to check regularly after three
years that the batteries are not leaking. If there is any sign of leakage or corrosion,
replace the battery pack. Ensure that only the battery pack LBB 4550/00 is used. The
battery pack has to be replaced at least every five years.
Installation and Operation manual
Integrus
Bosch Security Systems B.V.