Mounting On A Floor Stand - Bosch Integrus Installation And Operation Manual

34 en | Installation
Figure 5.9 Attaching the suspension bracket to the radiator
First assemble the supplied suspension bracket and connect it to the radiator (see Figure 5.8
and Figure 5.9). This bracket is attached to the radiator by two bolts with washers. There are
corresponding holes on the back of the radiators. There is also a spring-loaded plunger
(indicated by a black arrow in Figure 5.9), located above the bolt hole on the right-hand arm of
the bracket, which is used for adjusting the angle of the radiator (shown in inset in
Figure 5.9). There are corresponding holes on the back of the radiator for accepting this
plunger. The mounting angle can be adjusted in steps of 15°.
5.4.2

Mounting on a floor stand

Figure 5.10 Attaching the stud of a floor stand to the suspension bracket of the radiator
IOM-INT | V1.1 | 2010.12 Installation and Operation manual
Integrus
Bosch Security Systems B.V.