Integrus
4.
5.
6.
7.
5.3.2
Installation of the INTK
Follow the instructions below to install the INT-TXK. The numbers refer to Figure 5.6 and
Figure 5.7.
6
7
Figure 5.6 Installation of the INT-TXK (steps 1 - 6)
Bosch Security Systems B.V.
Remove the analogue input/output PCB (2):
–
Loosen the screws (3) between the cinch plugs on the rear panel (4). The number of
screws depends on the transmitter type.
–
Loosen the screws (5) at the XLR connectors on the rear panel.
–
Loosen the screws (6) of the distance studs (7) of the analogue input/output PCB.
Do not lose the (spring) washers (8).
–
On the main PCB (9) detach the flexible cables(10) to the analogue input/output
PCB. To this end release the catches (11) on both sides and pull out the flexible
cable. See inset in Figure 5.4.
–
Remove the analogue input/output PCB.
Remove three distance studs (7A, 7B and 7C) of the analogue input/output PCB.
On the main PCB (9):
–
Detach the user interface cable (12).
–
Detach the power supply connector (13).
–
Loosen the screws (14) of the distance studs. Do not lose the (spring) washers (15).
Remove the main PCB.
2
8
9
1
4
3
1
Installation and Operation manual
10
11
18
5C
5B
5A
Installation | en
31
IOM-INT | V1.1 | 2010.12