Table of Contents
Advertisement
g
EV Charging Station
recommended to configure the EV100 application to use port 9500 (by default) and all EVSE in
the network to also use port 9500 (factory default is 9000).
Note: The port number on all EVSE in the network must match the port number defined
during the EV100 Software installation.
Enable DHCP
Keep this option disabled at any time.
Allow charging if communication is not established
By default, this option is not selected. Checking this box will modify the behavior of the EVSE in
the case of network loss:
If unchecked, the EVSE will not allow charging of a car in the case of network communication
failure between the EVSE and the Host PC.
If checked, the EVSE will allow charging of a car despite of a network communication failure.
Station ID information
Fill in the Station ID information to distinguish EVSE from each other in the EV100 Application. It
Action
is important to give each EVSE a unique ID.
required !
IDs will appear in the EV100 Application in the format "1-12-9" (e.g. Locality ID = 1, Facility ID =
12, Unit number = 9).
Note: The Station ID information is how the EV100 application distinguishes between
stations in the same network. Make sure you assign different values to each EVSE.
Note: In the case of any modification of the "Require authentication for charging"
status, or after a reset or replacement of the controller, the Station ID must be modified
to a new ID not previously used on this network to avoid transaction data to be lost.
After the desired settings were configured click on "Save".
Repeat this procedure for all EVSE in the network.
GE EV Charging Station User Manual
User Manual & Installation Instructions
76 of 86
Advertisement
Table of Contents
