Table of Contents
Advertisement
g
EV Charging Station
Note: In the case of any modification of the "Require authentication for charging"
status, or after a reset or replacement of the controller, the Station ID must be modified
to a new ID not previously used on this network to avoid transaction data to be lost.
Host IP address.
By default, the IP address is set to 192.168.2.19. Unless there is a collision with another setup, it
is recommended to keep this host address.
Should this address change, the network PC will need to be configured accordingly in the
TCP/IP settings, as explained later below.
TCP Host Port & TCP Source Port.
Change the value to 9500 for both the Host and Source Port to match the default value of the
Action
EV100 Application SW. Unless there is a collision by using this Port on the host PC, it is
required !
recommended to configure the EV100 application to use port 9500 (by default) and all EVSE in
the network to also use port 9500 (factory default is 9000).
Note: The port number on all EVSE in the network must match the port number defined
during the EV100 Software installation.
Enable DHCP
Keep this option disabled at any time.
Allow charging if communication is not established
By default, this option is not selected. Checking this box will modify the behavior of the EVSE in
the case of network loss:
If unchecked, the EVSE will not allow charging of a car in the case of network communication
failure between the EVSE and the Host PC.
If checked, the EVSE will allow charging of a car despite of a network communication failure.
Station ID information
Fill in the Station ID information to distinguish EVSE from each other in the EV100 Application. It
Action
is important to give each EVSE a unique ID.
required !
IDs will appear in the EV100 Application in the format "1-12-9" (e.g. Locality ID = 1, Facility ID =
12, Unit number = 9).
GE EV Charging Station User Manual
User Manual & Installation Instructions
69 of 86
Advertisement
Table of Contents
