Canon CXDI-80C Service Manual page 58

1) Select [Service Tool] → [Connection] → [Detector], and then open the [Ferry Static Detector] screen.
2) Select the detector to be used by the wireless and wired connection.
3) From the [IP] tab, set [Use wired option] of [Wired] to ON, set the target IP address, and then register
the detector again.
• For details, refer to "Appendix6 AP/LINK Configuration Tool" in Chapter 4. Setting reference of
the CXDI Control Software NE V.1.40 Service Manual.
Note:
* Allocate different IP addresses when using both wireless and wired connections with one detector.
Example: Serial no. 19000001
IP address for wireless connection:
IP address for wired connection:
[Reference] The table below shows the status display patterns of the LED display provided on the
detector.
Category
Power-related statuses Power OFF
Power ON
Remaining battery charge level 8 to 5%
(replace battery)
Remaining battery charge level 4 to 0%
(no imaging possible)
Communication-related LAN LINK not completed
statuses
LAN LINK completed
Imaging data transfer underway
Imaging data transfer error
Maintenance-related statuses Software update underway or backup code
startup processing underway
Software update error or backup code start
error
Infrared Infrared communication underway
communication-related (detector registration underway)
statuses Infrared communication completed
(detector registration completed）
Infrared communication error
Operation-related statuses Startup error
FPGA configuration error
Other error
Detection status-related At startup
statuses
Initialization underway
Selection enabled
Selected status
Imaging preparations underway
Imaging enabled and imaging underway
: Lights, : Off,
○ ×
*1
: Depending on the remaining battery charge, the LED concerned either "
" " (blinks).
☆
*2
: "LAN LINK completed" refers to the status in which the access point and the wireless
communication system or wired communication system are linked.
*3
: A mode in which two or more LEDs concerned "
2. Installation procedures
Item
*2
*3
*3
*3
*3
*3
*3
: Blinks, : Blinks slowly, –: Any status, ( ): Not controlled
☆ ★
- 25 -
192.168.100.11 (assigned automatically)
192.168.100.12 (changed manually)
POWER READY
Blue Green
× （×）
○ －
★ －
☆ －
1
※
○/★/☆ －
1
※
○/★/☆ －
1
※
○/★/☆ ○/★
1
※
○/★/☆ ☆
（○） －
（○） ☆
1
※
○/★/☆ ×
1
※
○/★/☆ ○
1
※
○/★/☆ ☆
☆ ☆
☆ ★
☆ ☆
○ ○
1
○/★/☆ ※ ×
1
※
○/★/☆ ×
1
※
○/★/☆ ★
1
※
○/★ ☆
1
※
○/★ ○
" (blink) indicates an error.
☆
LINK Remark
Blue-green
（×）
－
Low remaining
－
battery charge
Battery error
－
×
Line established
○
★
☆
★
Indicated for
☆
5 seconds
☆
Indicated for
○
1 second
Indicated for
☆
3 seconds
★
☆
☆
Indicated for
○
1 second
－
（○）
（○） Sleep status
（○）
（○） Ready status
" (blinks slowly) or
★