Mounting The Pca-Xif Board - Canon CXDI-80C Service Manual

3.2.2.2 Mounting the PCA-XIF board

1) Insert the LAN cable connector, AC adapter connector (DC inlet) and LED of the PCA-XIF
board through the holes in the base, and lay the PCA-XIF board flat.
* The shielded plate that covers the LAN cable connector is made electrically conductive
with the edge by pushing it into the hole in the base.
PCA-XIF board
2) Using the DC inlet position as reference, adjust the position of the PCA-XIF board.
* The end of the DC inlet must protrude by about 0.1 mm from the base wall.
Wall of X-ray interface box base
3) Secure the PCA-XIF board using the eight screws (XB1-2300-606).
Reference:
Tightening torque: 58.8 N-cm (6 kgf-cm)
4. Repair Guide
DC inlet
- 6 -
X-ray interface box base
Protrusion amount: Approx. 0.1 mm
XB1-2300-606 screws (x 8)