Other Reference Information; Changing The Ip Address Of The Pca-Xif Board - Canon CXDI-80C Service Manual

5.3 Other reference information

5.3.1 Changing the IP address of the PCA-XIF board

The IP address of the PCA-XIF board can be changed or checked using the "ipadr" command in the
telnet connection status.
Example 1: When changing the IP address from "192.168.100.96" to "192.168.100.97"
XIF_GUEST>ipadr∆-ip∆192.168.100.97 (where ∆ is a half-size space)
* The power must be turned off and turned back on for the new setting to be reflected.
* To set the IP address of the PCA-XIF board into the detector, start the AP/LNK
configuration tool of Service Tool, and take the following steps.
1) Input the IP address (192.168.100.97 in this case) of the PCA-XIF board which has
been changed to the X-ray interface address on the Configuration tab screen, and
press the "Save" button.
2) Bring the infrared communication area of the detector close to the infrared
communication unit, and proceed with the LINK operation.
(Commentary)
After "ipadr-ip 192.168.100.97" has been input, the "New setting takes effect after power cycling"
message is displayed. Before turning the power back on, input "ipadr," and when the current status is
checked, "192.168.100.96" will be displayed for Current and "192.168.100.97" for the flash memory.
At this point in time, it is clear that only "192.168.100.97" has been written in the flash memory and that
the new setting has not been reflected.
Screen on which to change and check the IP addresses
4. Repair Guide
- 23 -