Siemens SIDOOR ATD4 W Series System Manual page 302

Connecting and commissioning
10.6 Commissioning the control unit on the fieldbus
Commissioning the control unit on PROFIBUS
We recommend the following initial commissioning procedure for a control unit as DP slave on
PROFIBUS DP:
Table 10-2
Step
1
2
3
4
5
6
7
Commissioning the control unit on PROFINET
We recommend the following initial commissioning procedure for a control unit as IO device on
PROFINET IO:
Table 10-3
Step
1
2
3
4
5
6
7
300
Procedure for commissioning the control unit as a DP slave on PROFIBUS DP
Procedure
Commission the control unit without a fieldbus connec‐
tion as described in the previous sections.
Configure the DP master (including PROFIBUS address)
Switch on supply voltage for DP master
Switch on supply voltage for control unit (DP slave)
Load the configuration in the DP master
Switch DP master to RUN mode
Controlling LEDs on the control unit
Procedure for commissioning the control unit as an IO device on PROFINET IO
Procedure
Commission the control unit without a fieldbus connec‐
tion as described in the previous sections.
Configuring an IO controller
Switch on the supply voltage for IO controller
Switch on supply voltage for control unit (IO device)
Load the configuration into the I/O controller
Switch I/O controller to RUN mode
Controlling LEDs on the control unit
See...
Sections Preparing the control
unit (Page 295) to Connecting
digital inputs (Page 299)
Documentation of the DP mas‐
ter
Documentation of the DP mas‐
ter
Connecting the power supply
to the network and executing
a learn run (Page 298) section
Online help of the configura‐
tion tool, e.g. STEP 7
Documentation of the DP mas‐
ter
Final settings and checks
(Page 301) section
See...
Sections Preparing the control
unit (Page 295) to Connecting
digital inputs (Page 299)
Documentation of the IO con‐
troller
Documentation of the IO con‐
troller
Connecting the power supply
to the network and executing
a learn run (Page 298) section
Online help of the configura‐
tion tool, e.g. STEP 7
Documentation of the IO con‐
troller
Final settings and checks
(Page 301) section
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA