Table of Contents
Advertisement
Command Index and Defaults
FACTORY OPTION SET # 2
(Asynchronous Dial-up without V.42bis Protocol) (AT&F2)
• MODEM OPTIONS
DCE rate - 28800
Modulation automode
V.34 rate threshold low *
V.34 asymmetric rate enabled
Normal originate
Fast train disabled
Auto retrain enabled
Sq auto rate disabled
Transmit clock internal
Dial line
Jack type RJ11 (permissive)
Line current disconnect long
Long space disconnect enabled
V.22 guard tone disabled
• PROTOCOL OPTIONS
LAPM protocol disabled *
MNP protocol disabled *
Normal buffer mode *
Constant DTE speed
DTE flow control disabled *
DCE flow control disabled *
XON/XOFF pass through disabled * Async controlled dialer
Inactivity timer off
Break control 0 *
V.42 fast detect disabled *
• SPEAKER OPTIONS
Volume medium
On until carrier detect
* Indicates variation from factory option set #1
E-20
•
TEST OPTIONS
Bilateral analog loop disabled
Bilateral digital loop disabled
DTE local test disabled
DTE remote test disabled
Remote commanded test enabled
Test timeout off
•
DIAL LINE OPTIONS
Tone dial
Auto dial #1
Wait for dial tone
Wait delay 2 seconds
Pause delay 2 seconds
Call timeout 30 seconds
Answer on 1 ring
801 V.32 timeout long
Autocallback disabled
•
DTE OPTIONS
Async data
DTE rate - 9600
8 bit, No parity
AT command set enabled
Ignores DTR
DSR forced high
DCD forced high
CTS follows RTS *
DTE fallback disabled
Options retained at disconnect
V.3400
Advertisement
Table of Contents
