Table of Contents
Advertisement
Individual information requirement method selection field
Selects the individual information requirement method (Auto/Manual)
Manual:
Manually selects the unit in which the individual information is required.
Auto (IDA mode): Automatically selects the unit in which the individual information is
Require-
ment
method
Manual
Auto
(IDA mode)
Adaptor selection field
Selects the transmission adaptor which connects the target unit.
Check All setting field
When this checkbox is checked, all Unit Types at
checkbox is unchecked at the list of
118
required. The selection of the unit in which the individual information
is required differs depending on the monitor screen display state.
(Refer to the table below.)
When Auto is selected,
Monitor screen
display state
―――
(Target in which the indi-
vidual information is re-
quired does not depend
on the display state)
Not displayed
System List screen
Operation History screen
Error History screen
Detail Diagram screen
Detail Status List screen
Detail Check List screen
Graph screen
to
are not displayed.
Target in which the individual infor-
State
Units in all refrigerant circuits con-
nected to the adaptor selecting on
All
this setting screen (when all check-
boxes of Ref. No. and Unit No. are
checked by this setting)
Some refrigerant circuits and units
Selected
connected to the adaptor selecting
on this setting screen
Not displayed
Units in all refrigerant circuits con-
All
nected to the adaptor selecting on
the displayed monitor screen
Units in the adaptor selecting on
Ref. No. value
the displayed monitor screen or in
the refrigerant circuit
State
and
are selected. (When the
, the selection can be cancelled individually.)
Copyright© 2009-2017 Fujitsu General Limited. All rights reserved.
mation is required
All units
Advertisement
Table of Contents
