Mitsubishi Electric MELSEC-Q Series User Manual page 763

Related buffer memory address
28480+100n
70+150n
4318+100n
4319+100n
4317+100n
Refer to Section 5.4
"List of block start data"
Set range
(Setting with sequence program)
—
[RJ010 mode] 0, 4, 5, 6, 7
[CiA402 mode] 8
<JOG speed>
1 to 1000000000 [PLS/s]
-2
1 to 2000000000 [ 10 mm/min or others]
<Inching movement amount>
0 to 65535
<Condition data No.>
1 to 10
16 - 17
Chapter 16 Troubleshooting
Remedy
Set "0: Need to pass servo motor Z-phase after power on" in
the servo parameter "Function selection C-4 (PC17)".
Correct to the available HPR method.
Bring the JOG speed into the setting range.
(Refer to Section 11.2)
Set a smaller inching movement amount so that the setting
condition is satisfied.
(Refer to Section 11.3)
Review the condition data No.
(Refer to Section 5.4 [Da.14])
n: Axis No.-1